V2 Water/Methanol Injection Standard Controller Kit Part 30-3304 with Internal Sensor Progressive Boost Controller

It applies boost based progressive injection control logic. The unit adjusts injection output according to real time boost pressure instead of simple on off switching mode.

Integrated internal pressure sensor accurately captures real time boost pressure signal from turbo system to support precise flow regulation.

Injection flow will increase proportionally as boost pressure goes up. It matches fuel demand changes of modified engines under different load conditions.

End users can manually set the boost point where injection starts working by turning the adjustment knob on device surface.

The threshold for full flow output can also be manually configured. Tuners can match parameters according to actual engine modification level.

The starting injection point supports adjustment within 1 to 11 PSI, which covers most daily street turbo vehicle working scenarios.

Full flow output threshold can be tuned from 5 to 35 PSI, meeting high boost requirement for track racing heavily modified engines.

Wide parameter calibration range makes this unit compatible with both street daily modified cars and professional track racing turbo power units.

This controller reserves external fail safe trigger output interface to build complete system protection for whole water methanol setup.

It can send out warning trigger signal when detecting low fluid level, circuit fault and other abnormal system operating status.