Kk-2000c Two/Three Pin Plug Pin Crimp Machine

This usually occurs because the terminals are not fully blocking the photoelectric sensor's light beam. Please check the following: Ensure the terminals completely cover both ends of the optical fiber light beam. Check if the photoelectric sensor is dirty or obstructed by dust or debris. Clean the sensor lens gently if needed. Verify that the terminals are properly positioned on the linear vibrator track. If the issue persists, check whether the sensor alignment has shifted and readjust it t

This issue is typically related to the front delay setting or sensor contamination. Please try the following: Check if the front delay is set too long. If so, turn the delay knob counterclockwise to shorten the delay time. Inspect the photoelectric sensor for dust, oil, or debris that may be blocking the light beam. Clean it carefully. Make sure the terminals have completely moved out of the sensor's detection range so the light beam is fully reconnected. If none of these resolve the issue,

Excessive noise is almost always caused by metal-to-metal contact between components due to insufficient clearance. Please check the following gaps: Vibrating feeder to linear vibrator: Should be approximately 1mm. Linear vibrator to mold/die: Should be approximately 1mm. If either gap is too small, the components will collide during vibration, creating loud noise. Loosen the mounting screws, adjust the gap to about 1mm, and retighten securely. Also, check if any foreign objects have fallen i

For immediate jamming recovery: Turn off the linear vibrator switch to prevent additional terminals from feeding forward. Press the manual control switch to retract the pin. Remove the jammed terminal. Turn off the manual switch to return the pin to its forward position. Turn the linear vibrator switch back on and resume operation.

Please follow these steps based on which component has weak vibration: For the Vibrating Feeder (yellow digital controller on the left): The display shows H= [value]. Press the up arrow key on the lower right of the controller to increase the value and vibration force. Press the down arrow to decrease it. For the Linear Vibrator (silver controller on the right): Turn the black knob in the center clockwise to increase vibration force, or counterclockwise to decrease it. Important Check: Ens