Pulverizer Grinder Simple Assembly Frame Serves Small Scale Chili Processing Workshops

Yes. The knife assembly is a field interchangeable unit. Operators remove the worn or wrong size set, install the replacement knives and restart. No factory service visit is required. We supply the correct spanner set and installation guide with each machine.

Both levers work. Fitting the corresponding mesh screen is the primary control. Fine tuning spindle speed within the 1000 to 2400 rpm range then narrows the distribution. For a tight 40 mesh cut, we recommend starting with the matching screen and dialing speed upward until yield stabilizes.

Blade life on abrasive material depends on hardness and daily run hours. The cutter is designed to be taken down, bench polished with standard grinding equipment and reinstalled at full performance. A local machine shop can do this without specialist tooling.

The CWHP 50 at 22 kW covers 300 to 1000 kg per hour and is built for continuous industrial duty. For 24 hour operation, plan a scheduled knife inspection every 8 hours and a brief chamber clean at each shift change to maintain consistent mesh output.

Standard build is 380V 50Hz three phase. We configure motors for 220V 50Hz single or three phase on request. Specify your local supply at order and we will supply the correct motor and control panel before shipment.