Two Dimensional Mixer Rotating Drum Swing Frame Blending Equipment

The CWED 5000 covers 1800 kg loading weight. If your material bulk density allows 2000 kg to fit within the 2500 liter loading volume, specify the CWED 5000. If the material is light and fluffy, the CWED 10000 at 3000 kg rated loading provides the volume headroom needed. Contact us with your material bulk density and we will confirm the correct model before order.

The two dimensional mixer achieves faster uniformity than a V mixer because the swing motion continuously disrupts settled material layers that form between rotation cycles. Compared to a ribbon blender, the two dimensional mixer covers larger batch volumes with simpler mechanical structure and lower maintenance requirement. For powder with bulk density below 0.6 g per cubic centimeter and batch weight above 500 kg, the two dimensional mixer typically reaches uniformity in 10 to 20 minutes versu

Yes. The rotation motor and swing motor are independent drive units with separate speed control. Rotation speed and swing frequency are set individually at the control panel. This lets operators run faster rotation for coarse granule blending and slower swing for fragile particle protection, or increase swing frequency for dense material requiring more aggressive lateral redistribution.

Yes. The drum opens fully for interior access. Stainless steel inner surfaces clean with water rinse and food approved sanitizing solution. Between pharmaceutical and food production, swab sampling of the drum interior before the first food batch confirms residue below the threshold required by your cleaning validation protocol. We supply a cleaning validation support package on request.

The CWED 15000 generates significant dynamic load during the swing cycle. A reinforced concrete floor with anchor bolt points per the supplied foundation drawing is required. We provide a foundation load specification document at order stage for your structural engineer to confirm slab capacity. Installation requires a crane rated for the heaviest single assembly section.