Weatherproof Sealant Silicone Planetary Hydraulic Discharge Machine

1. Unique mixing structure: Planetary mixers have revolving and rotating mixing blades to simulate the trajectory of planetary motion. Compared with the single mixing method of ordinary mixers, it can produce more complex and efficient material flow, greatly improve the mixing uniformity, and is especially suitable for materials with extremely high mixing precision requirements, such as electronic slurries, high-end cosmetic raw materials, etc. 2. High mixing efficiency: Due to its special motio

1. Material viscosity: For low-viscosity materials (such as some solvent-based coatings), models with higher speeds and relatively simple blades can be selected to achieve rapid mixing; for high-viscosity materials (such as silicone rubber and sealants), models with large torque, complex blade structure and the ability to stir deeply inside the material should be selected to ensure that the material is fully turned and mixed. 2. Material composition: If the material contains a large number of so

1. Wear observation: Check the surface of the blade regularly. If there is obvious wear and thinning, especially when there are gaps and deformations on the edge, which seriously affect the mixing effect, you need to consider replacing it. Generally, if the material is used frequently and the blades are worn out, they may need to be replaced every few months; if the material is mild and the frequency of use is low, the blade life can be up to several years. 2. Mixing effect evaluation: When the

1. Reason: On the one hand, it may be that the viscosity of the material is too large, the stirring resistance increases, and the motor generates too much heat due to long-term high-load operation; on the other hand, there is a problem with the equipment lubrication system, such as insufficient and deteriorated lubricating oil, which leads to increased friction between components and generates a lot of heat. In addition, cooling system failures, such as blockage of cooling water pipes and damage

1. Cleaning process: First, after the mixer stops running, empty the remaining material; then, add an appropriate amount of cleaning agent to the mixer (select a suitable cleaning agent according to the properties of the material, such as organic solvents to clean oily materials, alkaline cleaning agents to clean water-based materials), start the mixer at a low speed for a period of time, let the cleaning agent fully contact the inner wall and blades of the equipment, dissolve and flush the resi