High Precision Seeds Tray Seeder Vegetable Seed Sowing Machine for Nursery

It may be that the needle is not inserted into the seeds to pick them up. Adjust the depth screw to adjust the depth of the downward pressure. Check whether all the needles on the seeding plate are installed and whether there are any air leaks. Confirm that the needle size matches the seeds. If not, replace with an appropriate needle. Check if the seeding plate is properly installed. Improper installation may cause air leaks, affecting seed suction. Check if the seeds in the seed tray are evenly

When seeding large seeds or a large quantity of seeds, you can directly place the seeds in a flat tray for seeding (e.g., 50-cell or 32-cell trays). Install the precision seed suction holes, place the seeds evenly in the holes, and apply lubricating oil to the orange industrial belt periodically during seeding. When installing the precision seed-sucking holes, ensure the higher side is aligned with the hole-pressing position to prevent excessive seeds from jumping out during sowing. Due to size

Pull the tray with pre-pressed holes from below the precision seed suction holes to the seeding position, ensuring the edges align. Move the seeder head forward to the seed tray, at a height of approximately 2 centimeters, and quickly lower the head to allow the seeds to jump and be sucked in. Rotate the head 90 degrees to check the seeding effect. If double seeds occur, gently tap the head to shake off excess seeds; if seeds are not picked up, manually add them to ensure each needle head picks

During seeding, constantly monitor whether the air needles are blocked; if blocked, clear them immediately. Ensure safety during operation; if issues arise during operation, shut off the power before addressing them. After approximately 3 hours of operation, manually drain the air compressor once. The seeder should be regularly cleaned, maintained, and serviced to ensure proper operation. The seeder should be parked on a flat, solid surface and installed securely.

The minimum order quantity is 1 set.