High Holding Power Mooring Flipper Delta Hhp Anchor

It is recommended to clean the marine anchor every time the ship docks. During the voyage, the anchor comes into contact with seawater, sediment, etc. These substances are likely to adhere to the surface of the anchor body. If not cleaned in time, it will accelerate the corrosion of the anchor body. Just rinse the anchor body with fresh water and then use a brush to remove the dirt and rust on the surface.

Regularly check the anchor flukes to see if there are any deformations, cracks, or excessive wear. Visual inspection can be carried out, with key attention paid to the tips and curved parts of the anchor flukes. At the same time, non - destructive testing can also be carried out using flaw detection equipment to ensure that subtle cracks can be detected and the safe use of the anchor is guaranteed.

The pin shafts, rotating parts, and connection parts of the anchor need to be lubricated regularly. These parts move frequently during use. Lack of lubrication will lead to increased wear and affect the normal hoisting and lowering of the anchor. Use special marine lubricating grease and apply it according to the specified cycle.

When the marine anchor is not in use, it should be stored in a dry and ventilated place to avoid getting damp and rusty. If conditions permit, it is best to hang the anchor to prevent friction and corrosion from contact with the ground. At the same time, keep it away from chemical substances to prevent damage to the anchor body.

When slight rust is found, first use sandpaper or a wire brush to grind off the rust until the metal luster is exposed. Then, apply a layer of anti - rust paint for protection. Strengthen the observation of this part later to ensure that the rust does not spread.