12.4 GHz 50 Ohm PVC Jacket Coaxial RF Cable with Copper Braid Shield

This offering is a coaxial RF cable supplied as a cable construction. Its documented materials include a stranded bare copper inner conductor, polyethylene dielectric, bare copper braid outer conductor, and PVC jacket. The cable has a listed 50 Ohm impedance and RoHS compliance. End connectors, finished cable length, and suitability for particular equipment are not specified in the available information

The supplied specification describes an unterminated cable construction rather than a connectorized cable assembly. It lists a 7X0.752 stranded inner conductor, 7.24 mm dielectric O.D., 7.85 mm outer conductor O.D., and 10.30 mm jacket O.D. Weight is specified as 160 g/m, and the listed bend radius is 40 mm. Cut length, connector options, packaging, and included accessories are not stated and should be confirmed when ordering

The listed cable has 50 Ohm impedance and a maximum operating frequency of 12.4 GHz. Its electrical data includes 101 pF/m capacitance, 66% velocity, and 3700 Vrms voltage withstanding. Typical attenuation is stated as 0.07 dB/m at 100 MHz, 0.14 dB/m at 400 MHz, and 0.24 dB/m at 1000 MHz. These published values apply to the specified cable configuration

The cable structure combines a stranded bare copper inner conductor, polyethylene dielectric, bare copper braid, and PVC jacket. The jacket outer diameter is 10.30 mm, while the specified minimum bend radius is 40 mm. Its listed operating temperature range is -25 to +70 C, and the table states RoHS compliance. Connector interfaces and compatibility with specific devices are not provided in the source data

For selection, compare the required system impedance and frequency with the listed 50 Ohm impedance and 12.4 GHz maximum operating frequency. Mechanical requirements can be checked against the 10.30 mm jacket O.D., 40 mm bend radius, and 160 g/m weight. Environmental conditions should be compared with the -25 to +70 C temperature range. Please provide the required cable length and connector requirements, as these details are not specified