50 Ohm Coaxial RF Cable with PVC Jacket and Bare Copper Braided Shield

This offering is a coaxial RF cable for electrical and RF interconnection. It has a bare copper wire inner conductor, a polyethylene dielectric, a bare braided copper outer conductor, and a PVC jacket. The specified cable impedance is 50 ohm, and the maximum operating frequency is 1 GHz. The supplied information does not identify particular equipment applications, connector terminations, or finished cable assemblies

The listing documents one defined cable configuration rather than multiple documented alternatives. Its stated construction includes a 0.90 (0.18X19) bare copper inner conductor, 2.95 mm dielectric O.D., 3.60 mm outer-conductor O.D., and 5.00 mm jacket O.D. The dielectric is polyethylene and the outer jacket is PVC. Cable length, connector termination, packaging, and included accessories are not specified in the available information

The cable is specified with 50 ohm impedance, 101.05 pF/m capacitance, and 67% velocity. Its maximum operating frequency is 1 GHz, with typical attenuation of 0.15 dB/m at 100 MHz, 0.31 dB/m at 400 MHz, and 0.50 dB/m at 1000 MHz. The listed attenuation values increase across the stated frequency points. Voltage withstanding is specified as 5000 Vrms, while working voltage is 1400 Vrms

The cable uses a bare copper wire inner conductor, polyethylene dielectric, bare braided copper outer conductor, and PVC jacket. The listed finished jacket O.D. is 5.00 mm, and the specified bend radius is 25 mm. Its temperature range is -25 to +70 deg C, and RoHS compliance is listed. Connector types, mating interfaces, and compatibility with specific equipment are not provided in the source data

Buyers should compare the required system impedance with the specified 50 ohm cable impedance and confirm that the intended operating frequency does not exceed 1 GHz. Typical attenuation is provided at 100, 400, and 1000 MHz, so the applicable frequency and cable-run length should be considered together. The 5.00 mm jacket O.D., 25 mm bend radius, and -25 to +70 deg C temperature range should also be reviewed.