50 Ohm RF Cable with Dual Silvered Copper Shields and 4.00 mm FEP Jacket

This product is an RF cable offered for internal electrical and RF interconnection. It is specified with 50 ohm impedance and an operating-frequency range from DC to 26.5 GHz. The stated construction includes a silvered copper center conductor, low-density PTFE dielectric, dual silvered copper shielding, and an FEP jacket. The supplied information describes the cable itself and does not identify a specific end-use application or additional service scope

The listed cable construction includes a 0.94 mm silvered copper center conductor, a 3.05 mm low-density PTFE dielectric, and a 4.00 mm FEP jacket. Its shielding combines silvered copper tape wrapping as the inner shield with braided silvered copper wire as the outer shield. The specified cable weight is 41 g/m. Cable length, connector types, terminations, and accessories are not stated in the supplied information

This RF cable is specified from DC to 26.5 GHz with 50 ohm impedance, 70% velocity, shielding effectiveness above 90 dB, and 1500 V DC voltage withstanding. Typical attenuation increases from 0.20 dB/m at 300 MHz to 2.65 dB/m at 26500 MHz. At those same listed frequency points, typical power changes from 552 W to 41 W. Additional typical power and attenuation points are provided from 1000 MHz through 18000 MHz

The cable uses a 3.05 mm low-density PTFE dielectric, followed by a 3.25 mm inner shield and 3.65 mm outer shield. Its finished FEP jacket has a 4.00 mm outside diameter. Static bend radius is specified as 20 mm and dynamic bend radius as 40 mm, while the temperature range is -55 to +125 deg C. No connector interface or equipment-specific compatibility is identified in the supplied data

For selection, confirm that the intended system uses 50 ohm cable impedance and operates within the stated DC to 26.5 GHz range. Routing should account for the 20 mm static bend radius and 40 mm dynamic bend radius, and conditions should remain within the -55 to +125 deg C temperature range. Provide the required cable length and any connector or termination requirements when making an inquiry, as these details are not specified.