DC to 16 GHz 50 Ohm Shielded Low-Loss RF Cable with Silvered Copper Conductor

This product is a low-loss RF cable intended for signal transmission within its specified DC to 16 GHz operating range. It has a 50 ohm cable impedance and a listed velocity of 76%. The supplied data define its conductor, dielectric, shielding, jacket, electrical characteristics, bend radii, temperature range, and typical attenuation and power values. Specific equipment uses or end-use applications are not identified in the available information

The supplied specifications describe one defined cable construction with a 2.30 mm silvered copper center conductor and a 6.80 mm low-density PTFE dielectric. Shielding consists of a self-adhesive aluminum foil inner layer and a braided silvered copper wire outer layer, followed by a bluish PFA jacket with 8.10 mm O.D. The listed cable weight is 134 g/m. Cable length, connector type, termination, and package contents are not specified

The cable is specified for DC to 16 GHz operation, with shielding effectiveness above 70 dB and voltage withstanding of 2500 V DC. Typical attenuation increases from 0.08 dB/m at 300 MHz to 0.76 dB/m at 16000 MHz. The corresponding listed power values decrease from 3627 W at 300 MHz to 382 W at 16000 MHz. These attenuation and power figures are stated at 25 C and sea level

No connector interface is identified in the supplied specifications, so compatibility with a particular connector or terminated cable assembly is not stated. The cable has 50 ohm impedance and an 8.10 mm jacket outer diameter. Its specified static bend radius is 41 mm, while its dynamic bend radius is 81 mm. The listed operating temperature range is -55 to +125 C

For selection, compare the required signal range with the specified DC to 16 GHz operating range and confirm suitability for a 50 ohm cable path. Review the typical attenuation and corresponding power values at the frequency nearest the intended operating point, noting their stated 25 C and sea-level condition. Mechanical planning should consider the 8.10 mm outer diameter and the 41 mm static and 81 mm dynamic bend radii.