DC to 18 GHz 50 Ohm Low Loss Shielded RF Test Cable for Interconnection

This RF cable is offered for high-power, low-loss test interconnection. It has 50 Ohm cable impedance and an operating frequency range from DC to 18 GHz, while the table also lists shielding effectiveness greater than 90 dB and 2500 V DC voltage withstanding. Connector types, supplied length, and specific end-use applications are not stated in the available product information

One cable configuration is specified in this listing. Its overall jacket outside diameter is 7.62 mm and its weight is 130 g/m; the listed static and dynamic bend radii are 38 mm and 76 mm, respectively. The supplied information does not identify finished cable length, connector terminations, accessories, packaging, or preassembled ends. Confirm these deliverable details with the seller before ordering

The cable is specified for DC to 18 GHz operation with 50 Ohm impedance and 78% velocity. Typical attenuation increases from 0.10 dB/m at 300 MHz to 0.83 dB/m at 18000 MHz. At those same endpoints, the listed typical power values decrease from 2917 W to 334 W. Additional attenuation and power points are provided at 1000, 3000, 6000, 8500, and 12400 MHz

The stated temperature range is -55 to +200 degrees C, with a 38 mm static bend radius and a 76 mm dynamic bend radius. The cable also has a 7.62 mm overall jacket outside diameter and shielding effectiveness greater than 90 dB. Its 50 Ohm impedance should be checked against the intended RF path. Connector interfaces, mating standards, and enclosure compatibility are not identified in the supplied information

Confirm that the intended operating frequency is within the DC-to-18-GHz range and that 50 Ohm impedance matches the RF path. Compare the required operating point with the applicable typical attenuation and power values, which are tabulated from 300 to 18000 MHz. Provide the required cable length and termination details because they are not specified.