DC to 67 GHz Lightweight Flexible Shielded 50 Ohm RF Cable Signal Transmission RF Cable

This listing is for a lightweight, shielded flexible RF cable for RF signal transmission. Its specified operating range extends from DC to 67 GHz, and its cable impedance is 50 ohms. The construction includes a silvered copper center conductor, low-density PTFE dielectric, tape-wrapped inner shield, braided outer shield, and grey PFA/FEP jacket. The supplied product information does not state an application-specific end use

The supplied parameter table identifies one cable configuration for this listing and does not show separately named alternatives. It specifies a 0.51 mm center conductor O.D. and a 2.20 mm finished jacket O.D., along with silvered copper and low-density PTFE construction materials. The information describes the cable itself and does not state included connectors, cable length, terminated assemblies, or accessories.

The cable is specified for DC to 67 GHz operation with 50 ohm impedance, 82% velocity, and shielding effectiveness above 90 dB. Amplitude stability versus flexure is below +/-0.1 dB, while mechanical phase stability is below +/-5 degrees. At 25 degrees C and sea level, typical attenuation increases from 0.35 dB/m at 300 MHz to 5.93 dB/m at 67000 MHz. The corresponding listed power values decrease from 179 W to 10 W across those frequency points

The RF cable has layered shielding formed by a silvered copper tape-wrapped inner shield and a braided silvered copper wire outer shield. Its low-density PTFE dielectric has a 1.45 mm O.D., while the grey PFA/FEP jacket gives the finished cable a 2.20 mm O.D. Static and dynamic bend radii are 11 mm and 22 mm, respectively, and the temperature range is -55 to +125 degrees C. Connector type and mating-interface details are not stated in the supplied table

For selection, compare the required frequency range with the specified DC to 67 GHz operating range and confirm that 50 ohm impedance is suitable for the intended system. Mechanical conditions can be checked against the 11 mm static bend radius, 22 mm dynamic bend radius, 10 g/m weight, and -55 to +125 degrees C temperature range. The supplied information does not define connector type, cable length, or a required inquiry format.