Customizable High Precision Cylinder Hydraulic Cylinders for Garbage Truck

Measure the outer diameter of the cylinder, then measure the length between pin holes (with the center rod pushed all the way in to the cylinder) to get the approximate push/pull length, then measure the diameter of the push/pull rod. If you have a pin in the attachment points, measure the diameter of the pin (usually 3/4 inch or 1 inch diameter). This will give you a reading of something like a cylinder (3 inches inside) for 3 1/4 inches outside, type of attachment points, size of pins, and ove

Four ways. 1) Send us the drawing if you have one; 2) Measure the size of the sample if you have one; 3) Send us a sample if possible; 4) Look closely at the chart; the retracted length must match what you have; the extended length may vary a little. The rod size is the shaft that moves in and out; you can see and measure that; the bore is the inside of the main housing that you can't see or measure unless it's apart. Order mainly by length, not bore and stroke, then get the rod size as close as

Double-acting: have a port at each end, supplied with hydraulic fluid for both the retraction and extension. Single-acting: hydraulic fluid enters through a port at one end of the cylinder, which extends the rod by means of an area difference. An external force or gravity returns the piston rod.

Red, black, others as required.

Yes! Package and logo will be made according to your requirements.