Consistent Cutting Performance Diamond Polishing Grinding Disc for Casting Edge Grinding

Hand-held cutting is highly operator-sensitive. Pressure, alignment, vibration and handling can change wheel wear dramatically. For purchasing trials, compare discs on the same casting type with similar cut length, grinder, operator method and pressure; otherwise 'disc life' alone can be misleading.

Too little pressure can glaze the abrasive surface and reduce cutting action; too much can break the wheel down faster. The practical target is stable cutting without forcing the grinder. Evaluate cutting time together with disc consumption instead of optimizing either metric alone.

When a wheel loads and starts rubbing instead of cutting, heat can rise quickly. Casting condition, wheel condition, feed pressure and cooling all influence burning. If heat increases during production, treat it as a process signal rather than simply increasing grinder pressure.

High-chrome white iron is a separate qualification case. Engineering discussions report heat-check and cracking risks when grinding these very hard castings. This SEFU range is intended for gray iron, ductile iron and cast steel, so do not transfer the same wheel choice automatically to high-chrome white iron.

Not necessarily. Users report that thinner wheels can cut faster, but excessive pressure may consume them much more quickly. Evaluate total cost by cutting time, discs consumed, grinder load and change frequency. In this range, thickness is model-linked: 1.6 mm or 2.5 mm.