Pn16 HDPE PP Compression Fitting Male Threaded Adaptor Coupling for Water Supply

PP compression fittings are very easy to install, which involves the following steps: Preparing the pipe, removing the burrs and beveling the edge of pipe. The outer surface of the pipe must be free from imperfections or indentations where the body of the fittings make contact with the pipe. Unscrewing the blue nut and put it into the pipe followed by the white clamping ring. Make sure the clamping ring is in the correct position, with the larger mouth outwards to the edge of pipe. Pressing the

It is critical to avoid over-tightening the nut or else the integrity of the poly compression fitting will be compromised by the excessive force. If the nut is overtightened the ferrule will deform improperly causing the joint to fail. Indeed, overtightening is the most common cause of leaks in PP compression fittings.

Yes, all HDPE pipe compression fittings are UV-resistant, and can be used outdoor.

It is hard to say. HDPE compression fittings are only be possible for small diameter pipe till 110mm, while HDPE fusion fittings are available for all sizes. By comparison to HDPE fusion fittings, Poly pipe compression fittings are easy install, less cost, and are especially useful in installations that may require occasional disassembly or partial removal for maintenance etc., since these joints can be broken and remade without affecting the integrity of the joint. The disadvantage is PP compre

Mass stock is available for regular sizes. About 10 days for a 20ft container and 20 days for a 40ft container.