1500W Enclosed Precision Laser Welding Machine for Thin Parts

The 1500W precision configuration is optimized for thin-gauge materials from 0.5mm to 2mm. Stainless steel and carbon steel weld well across this full range. Copper, due to its higher thermal conductivity, is best welded up to approximately 1.5mm at 1500W. For materials consistently above 2mm, higher power options may provide the additional penetration needed.

A 3000W source turned down to 1500W-equivalent output operates at the bottom of its control range, where adjustment resolution is reduced. The 1500W configuration runs within its designed power band for thin-gauge work, providing finer control over pulse energy, duration, and frequency. The 220V single-phase power supply also simplifies installation compared to the 380V three-phase requirement of higher-power machines.

Yes. The 1500W configuration with fine-focus optics provides sufficient energy density to overcome copper's high reflectivity and thermal conductivity for sections up to approximately 1.5mm. Pulse shaping with a leading high-energy spike helps establish the initial weld pool on reflective copper surfaces.

The machine operates on standard 220V single-phase power, which simplifies installation in most facilities. No three-phase power connection or special electrical infrastructure is required.

Yes. The control system stores dedicated weld programs for different materials, allowing you to switch between stainless steel and copper parts by selecting the corresponding program. Parameter settings for each material are saved and recalled without recalibration.