DC to 26.5 GHz 50 Ohm Dual Shielded FEP Internal Interconnect RF Cable

This product is an internal interconnect RF cable for electrical and RF signal interconnection. It has a specified 50 Ohm cable impedance and an operating frequency range from DC to 26.5 GHz. Its documented construction includes a silvered copper center conductor, low-density PTFE dielectric, dual shielding, and an FEP jacket. The supplied parameters do not identify a finished cable assembly, connector, or end-termination scope

The documented cable construction includes a 0.53 mm silvered copper center conductor and a 1.68 mm low-density PTFE dielectric. Shielding consists of a silvered copper tape inner shield with 1.85 mm O.D. and a braided silvered copper wire outer shield with 2.18 mm O.D. The cable is finished with an FEP jacket having a 2.65 mm O.D. Cable length, connector type, and termination format are not stated in the supplied parameter table

The RF cable is specified for operation from DC to 26.5 GHz, with shielding effectiveness above 90 dB and 1000 V DC voltage withstanding. Typical attenuation rises from 0.33 dB/m at 300 MHz to 4.07 dB/m at 26500 MHz. Over those listed frequency points, typical power decreases from 223 W at 300 MHz to 19 W at 26500 MHz. The stated power and attenuation figures are typical values

This RF cable has 50 Ohm impedance and a stated velocity of 70%. It weighs 20 g/m, with a 13.5 mm static bend radius and a 26.5 mm dynamic bend radius. The FEP jacket has a 2.65 mm outer diameter, and the specified temperature range is -55 to +125 deg C. Connector compatibility is not identified in the available data and should be confirmed separately

For selection, compare the required operating frequency with the documented DC to 26.5 GHz range and confirm that 50 Ohm impedance matches the intended interface. Check cable routing against the 13.5 mm static bend radius and 26.5 mm dynamic bend radius. Review environmental conditions against the -55 to +125 deg C temperature range and voltage requirements against the 1000 V DC withstanding value.