E01 Own Flood Control Hydraulic Lift Dam

The back side of the hydraulic elevator dam is supported by two hydraulic cylinders at a small Angle, powered by the hydraulic station, and the hydraulic oil is used as the medium to make the cylinder rod of the hydraulic cylinder move, so as to realize blocking and discharging flood. The lifting time of single gate is about 1min/m, and the lowering time can be adjusted in 30s-30min. The hydraulic elevator dam can achieve arbitrary dam high water retention.

The hydraulic elevator dam is able to withstand severe mud and sand sedimentation. It was specially designed for this purpose. The hydraulic dam may be adjusted up to a vertical angle of 75 degrees. This angle is large enough to completely wash away sedimentation under normal flow conditions. If sedimentation is not completely removed, the remainder will not be significant enough to affect the lifting and the dropping of the dam.

There may be large quantities of floating objects, such as tree branches, plastic bags, etc., which may serve as impediments to the normal operations of the hydraulic dam. Based on the quantity and location of these floating objects, regulation of a single dam or coordination with adjacent dams may be used for tackling this problem. These floating objects will eventually drift away with the help of the water flow. If stones are stuck in between the two dam surfaces, the dam's angle may be adjust

We can custom design the hydraulic pump station to achieve synchronous lifting and dropping of the dam 's surface. Importantly, if the flow and the power of the hydraulic pump are enhanced to accommodate the special needs of customers, the cost of the dam will also increase.

For areas without electricity, manual control can be achieved, its metal structure is the same as the hydraulic elevator dam, the power is powered by hand pump or diesel engine. For a river with multiple gates, only one mobile diesel engine is needed. Compared to the hydraulic elevator dam, investment will save about 30%-40%.